Raised Bed Builder
Shopping list
One lumber run plus soil. Prices below are per board at the price you entered (longer boards are scaled from it); soil is the big variable, and bulk by the yard beats bags for anything over about 15 ft³.
| Item | Qty | Each | Total |
|---|---|---|---|
| 2×6×8 ground-contact pressure treated | 6 | $9.58 | $57.48 |
| 2×4×8 ground-contact pressure treated | 2 | $4.98 | $9.96 |
| #9 × 2½″ exterior screws, star drive, 1-lb box (rated for treated lumber) (about 44 needed: long boards to the posts and stakes) | 1 | $10.98 | $10.98 |
| #9 × 3″ exterior screws, star drive, 1-lb box (rated for treated lumber) (about 40 needed: short boards to the posts, corners) | 1 | $10.98 | $10.98 |
| Cardboard (free) or ½″ hardware cloth for the bottom ($0–$25; hardware cloth stops gophers) | 1 | $0.00 | $0.00 |
| Total | $89.40 |
Soil (not in the total): raised-bed mix, 24 ft³ — 1 yd³ bulk, or 17 × 1.5 ft³ bags. Figure $45 bulk (plus delivery) or $136 in bags.
Tools: circular or miter saw, drill/impact driver with T25 bit, tape, speed square, 4′ level, shovel, sledge or mallet.
Every cut laid onto standard boards, longest first, with a ⅛″ saw kerf between pieces. Hatched space at the end of a board is offcut, and ×3 means cut three boards the same way. Use this at the saw to cut one board at a time.
2×6 × 8′
6 boards98% yield2×4 × 8′
2 boards72% yieldSides are 2×6 (or 2×4) boards stacked on edge and screwed to 2×4 corner posts inside the bed, with 2×4 stakes every 4′ or less on long sides so the soil can't bow them (deep beds also get a cross tie at each stake). Elevated beds stand on L-shaped 2×4 legs with a 2×6 slat floor. Modern pressure-treated lumber (copper azole / MCA) is rated safe for vegetable beds by the EPA; if you'd rather not, cedar or lined SPF are the alternatives. Board prices are the ones you enter; everything else is a typical big-box price.
- 1
Shopping list
One lumber run plus soil. Prices below are per board at the price you entered (longer boards are scaled from it); soil is the big variable, and bulk by the yard beats bags for anything over about 15 ft³.
Item Qty Each Total 2×6×8 ground-contact pressure treated 6 $9.58 $57.48 2×4×8 ground-contact pressure treated 2 $4.98 $9.96 #9 × 2½″ exterior screws, star drive, 1-lb box (rated for treated lumber) (about 44 needed: long boards to the posts and stakes) 1 $10.98 $10.98 #9 × 3″ exterior screws, star drive, 1-lb box (rated for treated lumber) (about 40 needed: short boards to the posts, corners) 1 $10.98 $10.98 Cardboard (free) or ½″ hardware cloth for the bottom ($0–$25; hardware cloth stops gophers) 1 $0.00 $0.00 Total $89.40 Soil (not in the total): raised-bed mix, 24 ft³ — 1 yd³ bulk, or 17 × 1.5 ft³ bags. Figure $45 bulk (plus delivery) or $136 in bags.
Tools: circular or miter saw, drill/impact driver with T25 bit, tape, speed square, 4′ level, shovel, sledge or mallet.
Ground-contact pressure treated: 15+ years; use screws rated for treated lumber. - 2
Cut list
Long sides are full 8′ boards (check they really are 96″; trim them to match if not). Cut the short sides, posts and stakes.
Tag Part Length Qty Cut L Long side, 2×6 96″ 4 square S Short side, 2×6 (fits inside the long boards) 45″ 4 square P Corner post, 2×4 23″ 4 45° point on the bottom K Mid stake, 2×4 23″ 2 45° point on the bottom Posts and stakes are 11″ of bed height plus 12″ to drive into the ground. Cut a 45° point on the bottom so they drive easier. - 3
Set the corner posts
Pick a spot with 6+ hours of sun. Mark the 8′ × 4′ footprint with stakes and string, and check it's square: the two diagonals should match.
- Drive a post at each corner, 12″ into the ground, so 11″ stands proud.
- Posts sit inside the corner, 1½″ in from each string line (the board thickness). Their wide face runs along the long side.
- Level the tops against each other with the 4′ level and a straight board.
- 4
First course
Set the two long boards on edge against the outside of the posts, then the short boards between them, tucked inside the long boards' ends.
- Three 2½″ screws through each long board into every post (the post is only 1½″ thick that way; a 3″ screw would poke through). Two 3″ screws through each short board into the edge of the post.
- Two 3″ screws through the long board end into the short board end grain at each corner. Pre-drill near the ends so they don't split.
- Level each board before screwing; dig or shim under low corners.
Check: diagonals match again before the next course locks it in. - 5
Stack the remaining courses
Repeat for the remaining 1 course, boards tight on top of the first, top course flush with the post tops.
- Same screws as the first course: three 2½″ per long board per post, two per short board end, offset from the ones below.
- Two 3″ screws at each corner joint.
- 6
Brace the long sides
Sides over 6′ bow outward once the soil is wet. Drive 2 stakes, 1 per long side at 48″ from the end (center), tight against the inside face, tops flush with the rim.
- Three 2½″ screws through each board into each stake.
- 7
Fill
Lay cardboard or hardware cloth on the ground inside the bed first. Fill with 24 ft³ of raised-bed mix to about 1″ below the rim (10″ deep). It settles, so top up after the first good watering.
- Cheap mix: ⅓ compost, ⅓ topsoil, ⅓ coarse material (bark fines or coco coir).
- 8
Done
Plant it. 8′ × 4′ gives you 29 ft² of growing space, 10″ of soil.
For North Texas: tomatoes, peppers and okra go in after mid-March; greens and brassicas in September for a fall crop.
Cut diagram
Every cut laid onto standard boards, longest first, with a ⅛″ saw kerf between pieces. Hatched space at the end of a board is offcut, and ×3 means cut three boards the same way. Use this at the saw to cut one board at a time.
2×6 × 8′
6 boards98% yield2×4 × 8′
2 boards72% yieldSides are 2×6 (or 2×4) boards stacked on edge and screwed to 2×4 corner posts inside the bed, with 2×4 stakes every 4′ or less on long sides so the soil can't bow them (deep beds also get a cross tie at each stake). Elevated beds stand on L-shaped 2×4 legs with a 2×6 slat floor. Modern pressure-treated lumber (copper azole / MCA) is rated safe for vegetable beds by the EPA; if you'd rather not, cedar or lined SPF are the alternatives. Board prices are the ones you enter; everything else is a typical big-box price.